Canon VB-M600VE - Manual (Page 98)

6
-20
The settings are reflected in the preview frame on the
panorama screen and the image display area.
If you previewed incorrect settings, etc., and want to
restore the settings registered in the camera, click
[Restore settings].
Note
• Up to 20 presets can be set.
• Changes to preset settings are not reflected in already
connected viewers.
• You can disable presets in the viewer by clearing the [Show in
viewers] checkbox under [Detailed settings].
• Preset positions cannot be set in the digital zoom area.
Preset Tour
Set a preset tour whereby the camera tours and monitors
the multiple presets currently set.
„ [Preset Tour] Tab Display Screen
(1) [Preset Tour] selection box.
Select when you want to perform a preset tour from
the following options.
[Not used]
Preset tour is not performed.
[For Viewers]
Preset tour is performed when a camera is
connected via the VB Viewer, etc.
[Always]
Preset tour is always performed.
(2) Tour schedule list
A list of presets set for preset tour.
(3) [Up] / [Down]
Select preset in the list and click [Up] or [Down] to
change sequence of the tour schedule list. Presets
tours are performed in order from the top of the list.
(4) [Delete]
Delete the preset selected from the tour schedule list.
(5) [Preset] selection box
Select the preset you want to add to the tour schedule
list.
(6) [Preview]
The camera angle switches to the selected preset,
and the new angle can be checked in the image
display area.
(7) [Speed (PT)]
Select [Slow], [Normal], or [Fast] for the moving speed
of the camera during panning/tilting.
3 Fine-tune the camera angle and adjust the image
quality with focus or smart shade control while
checking the image.
4 Click [Preview settings].
5 Click [Save settings].
Important
• To use presets in the viewer, select the [Show in viewers]
checkbox.
• If [Manual] is selected for [Focus Mode], manually adjust the
focus while checking the actual image in the image display
area. After the focus has been adjusted, set the focus using
[Get camera info]. Click [Save settings] to save the focus
settings.
• If the image stabilizer setting is changed after a preset has
been set, the viewing angle during operation will no longer
agree with the viewing angle at the time the preset was set
(p. 5-10). Check the preset settings again if the image
stabilizer setting is changed.
• If a dome housing is used, be sure to set presets with the
dome installed.
• Set presets again if the camera mounting conditions have
been changed.
(1)
(4)
(6)
(11)
(2)
(3)
(5)
(7)
(8)
(9)
(10)