Canon VB-M600VE - Manual (Page 127)

Performing Operations and Settings as the Administrator
7
-15
7
Adm
in V
ie
w
er/
V
B
Viewer
(2) Adjusting the Smart Shade Control
When smart shade control is [On], set one of the 7
levels from [1] (weak) to [7] (strong).
Example: If the background is bright and the subject
is hard to see, this function brightens dark areas to
make the subject clearer.
In comparison to backlight compensation, smart
shade control can reduce overexposure of bright
areas.
Note
• When [On] is selected for smart shade control, the image file
size increases.
• When [On] is selected for smart shade control, screen noise
may increase. If noise is noticeable, lower the control level.
Setting the Focus
[Auto] : Automatically focuses on the
subject.
[Manual] : You can adjust the focus manually
by pushing the (far) and
(near) buttons.
Clicking [One-shot AF] will use
autofocus to focus on a subject and
then stop in manual focus.
[Fixed at Infinity] : You can set the focus so that it is
fixed near infinity.
OFF Smart Shade
Control
BLC (Back Light
Compensation)
Important
• If it is set in the Admin Viewer, the same focus mode will
occur in the viewers of other users also.
• Setting the shutter speed at [1/1 sec] to [1/4 sec] in manual
exposure (p. 7-16) will disable the [Auto] (VB-M40 only) and
[One-shot AF] focus modes in camera control. Switch the
focus to [Manual] and adjust it to your subject.
• Refer to the following for focus ranges.
Notes on p. 3-8
Notes on p. 5-10
• Changes to focus mode in the Admin Viewer will not be
reflected in the settings on the setting page.
• Note that if you set the focus manually it will remain fixed.
• Depending on the lighting used, focus may not be
maintained when switching between [Day Mode] and [Night
Mode]. Focus when switching Day/Night Mode can be set in
the [Day/Night Mode Focus Settings] dialog in the Camera
Angle Setting Tool (p. 3-9).
• Use focus operations in the Admin Viewer for temporarily
checking subjects at other focal points. To fix a long-term
focal point, use the Camera Angle Setting Tool.