Configuring dlc on windows® nt/2000, Windows® 2000 printer setup, Configuring dlc on windows – Brother HL-7050N User Manual
Page 101: Windows, Nt/2000, 2000 printer setup
8 - 2 DLC PRINTING
YL4US_FAX2800MFC4800-FM5.5
Configuring DLC on Windows
®
NT/2000
To use DLC on Windows
®
NT, you must first install the DLC protocol.
1
Log into Windows
®
NT with administrative privileges. Go to the
NT Control Panel and double click on the Network icon.
Windows
®
2000 users select the properties of the Local Area
Connection.
2
On Windows
®
NT 3.5x systems, select Add Software. On
Windows
®
NT 4.0 systems, click on the Protocol tab, and click
Add. Windows
®
2000 users click the Install button from the
General tab.
3
Select DLC Protocol and then OK or Add if using Windows
®
2000. You may be asked for the location of the files. For Intel
based computers, the necessary files are stored in the i386
directory of the Windows
®
NT CD-ROM. If you have a non-Intel
platform, specify the correct directory on your Windows
®
NT
CD-ROM. Click Continue (for NT 3.5x systems) or Close (for
NT 4.0 systems).
4
Reboot your system to make the change take effect. Windows
®
2000 should not require a re-boot.
Windows
®
2000 Printer Setup
1
Log into Windows
®
2000 with administrative privileges. From
the Start menu, select Settings and then Printers.
2
Select Add Printer (If you have already installed a Brother
printer driver, double click the printer driver that you wish to
configure and then select Printers/Properties, select the Ports
tab, click on Add Port and continue from Step 6 (ignoring steps
11-14 about installing the correct driver)).
3
Click Next.
4
Select Local Printer and make sure that Automatically detect
and install my Plug and Play printer is not checked.
5
Click Next.