Badger Meter M-Series M2000 - Manual (Page 41)

Communication: Port Settings
Parity
[Even]
S
The following Parities are supported
• Even
• Odd
• None
To change the parity, follow these steps from the Port A Settings menu:
1 Select Parity to view the Parity display
2 Select one of the following: None, Even or Odd
3 Press [E] to save the option and to return to the Port A Settings menu
Stop Bits
[1 Stop Bit]
S
The Stop Bits parameter configures the port stop bits The following stop bits are supported:
• 1 Stop Bit
• 2 Stop Bits
To change the stop bits, follow these steps from the Port A Settings menu:
1 Select Stop Bits to view the Stop Bits display
2 Select one of the following: 1 Stop Bit, or 2 Stop Bits
3 Press [E] to save the option and to return to the Port A Settings menu
Communication: Port B
Port Address
[1]
S
An additional communication port, known as Port B, is used to offer enhanced communications with the
meter This port is located on the 11-pin terminal of the PCB Enhanced protocols like Hart, Profibus DP
or Modbus RTU over RS485 are available In addition, this communication port has similar configurable
properties as port A Refer to the following IOMs for additional information regarding the enhanced
communication capabilities of the M2000
• See IOM-191-XX-EN for details on HART® communication protocol
• See IOM-192-XX-EN for details on PROFIBUS DP communication protocol
• See IOM-193-XX-EN for details on MODBUS RTU communication protocol
Installation & Operation Manual
Page 41 August 2012