KROHNE H250 M40 FOUNDATION FIELDBUS - Manual (Page 69)

OPERATION
4
69
H250 M40
www.krohne.com 02/2014 - 4001208201 - AD H250 M40 FF R02 en
OUT_SCALE OUT_SCALE OUT_SCALE OUT_SCALE
Output Scale Output Scale Output Scale Output Scale
RW The high and low scale values, engineering units code and
number of digits to the right of the decimal point to be used in
displaying the OUT parameter and parameters which have the
same scaling as OUT.
EU at 100% RW The engineering unit value which represents the upper end of
range of the associated block parameter.
100
EU at 0% RW The engineering unit value which represents the lower end of
range of the associated block parameter.
0
Units Index RW Device Description units code index for the engineering unit
descriptor for the associated block value.
Uninitialized
Setting:
All units are possible.
Decimal Point RW The number of digits to the right of the decimal point which
should be used by an interface device in displaying the
specified parameter.
0
PV PV PV PV
Process Value Process Value Process Value Process Value
R This alert is generated by any change to the static data.
Status R Status of PV
Value R Value of PV
PV_FTIME PV_FTIME PV_FTIME PV_FTIME
PV F Time PV F Time PV F Time PV F Time
(Process Value (Process Value (Process Value (Process Value
Filter Time Filter Time Filter Time Filter Time
Constant) Constant) Constant) Constant)
RW Time constant of a single exponential filter for the PV, in
seconds.
0
Setting:
0.0…30.0
PV_SCALE PV_SCALE PV_SCALE PV_SCALE
Process Value Process Value Process Value Process Value
Scale Scale Scale Scale
RW The high and low scale values, engineering units code and
number of digits to the right of the decimal point to be used in
displaying the PV parameter and parameters which have the
same scaling as PV.
EU at 100% RW The engineering unit value which represents the upper end of
range of the associated block parameter.
100
EU at 0% RW The engineering unit value which represents the lower end of
range of the associated block parameter.
0
Units Index RW Device Description units code index for the engineering unit
descriptor for the associated block value.
Uninitialized
Setting:
All units are possible.
Decimal Point RW The number of digits to the right of the decimal point which
should be used by an interface device in displaying the
specified parameter.
0
RATE RATE RATE RATE
Rate Rate Rate Rate
RW Defines the derivative time constant, in seconds. 0
RCAS_IN RCAS_IN RCAS_IN RCAS_IN
Remote Cascade Remote Cascade Remote Cascade Remote Cascade
Input Input Input Input
R Target setpoint and status provided by a supervisory host to a
analog control or output block.
Status R Status of RCAS_IN
Value R Value of RCAS_IN
RCAS_OUT RCAS_OUT RCAS_OUT RCAS_OUT
Remote Cascade Remote Cascade Remote Cascade Remote Cascade
Output Output Output Output
R Block setpoint and status after ramping - provided to a
supervisory host for back calculation and to allow action to be
taken under limiting conditions or mode change.
Status R Status of RCAS_OUT
Value R Value of RCAS_OUT
Proportional Integral Derivative Block
Parameter
DD Name Access Description
settings Initial Value
AD_H250_M40_FF_R02_en_4001208201_PRT.book Page 69 Friday, February 21, 2014 11:25 AM