KROHNE H250 M40 FOUNDATION FIELDBUS - Manual (Page 56)

4
OPERATION
56
H250 M40
www.krohne.com 02/2014 - 4001208201 - AD H250 M40 FF R02 en
EU_0
Engineering Unit 0
RW The engineering unit value which represents the lower end of
range of the associated block parameter.
0.0
Units Index RW Setting:
All units are possible.
Decimal Point RW The number of digits to the right of the decimal point which
should be used by an interface device in displaying the
specified parameter.
0
OUT_TRIP OUT_TRIP OUT_TRIP OUT_TRIP
Output Trip Output Trip Output Trip Output Trip
RW The first discrete output.
Status RW Setting:
Good Non Cascade / Good Cascade / Uncertain / Bad Not
Connected / Bad
Bad Not Connected
Value RW Setting:
0: Off / 1: On
Off
OUTAGE_LIM OUTAGE_LIM OUTAGE_LIM OUTAGE_LIM
Outage Limit Outage Limit Outage Limit Outage Limit
RW The maximum tolerated duration for power failure. 0
Setting:
Positive or 0
PCT_INCL PCT_INCL PCT_INCL PCT_INCL
Percentage Percentage Percentage Percentage
Increment Increment Increment Increment
Calculation Calculation Calculation Calculation
R Indicates the percentage of inputs with good status compared
to the ones with bad or uncertain and bad status.
0.0
PRE_TRIP PRE_TRIP PRE_TRIP PRE_TRIP
Pre Trip Pre Trip Pre Trip Pre Trip
RW Adjusts the amount of mass, volume or energy that should set
OUT_PTRIP when the integration reaches (TOTAL_SP -
PRE_TRIP) when counting up or PRE_TRIP when counting
down.
0
Setting:
Positive or 0
PULSE_VAL1 PULSE_VAL1 PULSE_VAL1 PULSE_VAL1
Pulse Value 1 Pulse Value 1 Pulse Value 1 Pulse Value 1
RW Determines the mass, volume or energy per pulse. 0.0
Setting:
Positive or 0
PULSE_VAL2 PULSE_VAL2 PULSE_VAL2 PULSE_VAL2
Pulse Value 2 Pulse Value 2 Pulse Value 2 Pulse Value 2
RW Determines the mass, volume or energy per pulse. 0.0
Setting:
Positive or 0
RESET_CONFIRM RESET_CONFIRM RESET_CONFIRM RESET_CONFIRM
Reset Confirm Reset Confirm Reset Confirm Reset Confirm
RW Momentary discrete value which can be written by a host to
enable further resets, if the option confirm reset in
INTEG_OPTS is chosen.
Status RW Setting:
Good Non Cascade / Good Cascade / Uncertain / Bad Not
Connected / Bad / Bad No Comm with Last Useable Value
(LUV)
Bad Not Connected
Value RW Setting:
0: Off / 1: On
Off
RESET_IN RESET_IN RESET_IN RESET_IN
Reset Input Reset Input Reset Input Reset Input
RW Reset the totalizers.
Status RW Setting:
Good Non Cascade / Good Cascade / Uncertain / Bad Not
Connected / Bad / Bad No Comm with Last Useable Value
(LUV)
Bad Not Connected
Value RW Setting:
0: Off / 1: On
Off
REV_FLOW1 REV_FLOW1 REV_FLOW1 REV_FLOW1
Reverse Flow 1 Reverse Flow 1 Reverse Flow 1 Reverse Flow 1
R/W Indicates reverse flow when true.
Integrator Block
Parameter
DD Name Access Description
settings Initial
AD_H250_M40_FF_R02_en_4001208201_PRT.book Page 56 Friday, February 21, 2014 11:25 AM