KROHNE UFM 600T EN - Manual (Page 73)

3.6.4 INTERVAL (not visible if SEL. COMM is OFF)
Program the interval between successive data collections as
programmed in 3.6.3.
Range: 01 - 60 min
3.6.5 LOCATION : Location
If this function is activated the location, as programmed in the
Start Up Menu, is recorded in the header of each data block
that is stored or sent to RS 232.
Select YES or NO using the key and press to store.
3.6.6 RESET DATA
If STORE is programmed in function 3.6.3 all data blocks are
stored in the internal RAM.
With this function the RAM can be cleared, to be able to store
new data (up to 390 blocks).
NOTE: the parameter settings are not affected by this function.
Select YES or NO using the key and press to store.
70
ALTOSONIC
Programming mode
UFM 600 T