KROHNE UFM 600T EN - Manual (Page 62)

3.2.6 CYCL. DISPL. : Cyclic Display
The cyclic display option can be used to automatically
change the function of the display, if more than one variable
is programmed to be displayed.
Only one variable can be shown on the display at a time.
With this option active the display sequences from one vari-
able to the next every 5 seconds.
If the error messages are programmed to be displayed, these
appear in between the successive variables, if applicable.
For the totalizers and the flow rate, the actual function of the
display is indicated by an arrow symbol at the bottom of
the display.
If NO is selected the successive display of the varia-
bles is obtained by using the key.
59
▼