KROHNE UFM 600T EN - Manual (Page 59)

3.1.4 CUTOFF ON : (only if at 3.1.3 YES was
entered)
Program the flow rate level below which all outputs will be
switched off.
Enter the value in % of the full scale.
Range: 1- 20
NOTE: This value must be lower than the Cutoff Off value !!
3.1.5 CUTOFF OFF : (only if at 3.1.3 YES was
entered)
Program the flow rate level at which all outputs become
active again.
Enter value in % of full scale.
Range: 1- 20
56
ALTOSONIC
Programming mode
UFM 600 T