KROHNE UFM 600T EN - Manual (Page 25)

C.1.2 Programming the application parameters
After the flowmeter has been switched on it will start in the
measuring mode.
Pressing twice the key enters the Start Up Menu.
In this menu the application related parameters can be pro-
grammed.
All functions are described in section C.2.
Push Button Functions
The flowmeter can be programmed by means of the three
keys located below the liquid crystal display.
By pushing the left-hand key 'ARROW RIGHT' the
parameter shown on the display will be activated
and the desired value can be entered or an option
can be selected.
After pushing the key in the middle 'ENTER' the
programmed information will be stored and the
program advances to the next parameter.
For entering numbers or letters the 'ARROW UP'
key must be used; this will increment the ASCII
value of the blinking character (next higher num-
ber or next letter in the alphabet).
If a selection from a table must be made the
'ARROW UP' key can be used to display the next
option in the table. After using the 'ARROW UP'
key without actually programming a parameter the
next parameter will be displayed.
24
ALTOSONIC
Operation
UFM 600 T