KROHNE OPTISWIRL 4070 EN - Manual (Page 58)

6
OPERATION
58
OPTISWIRL 4070
www.krohne.com 02/2013 - 4000150606 MA OPTISWIRL4070C R07 en
3.2.8 Tot. Conf.
→
Configure totalizer
(available if Maes.Inst =
Volume, see menu item
1.1.3)
m 3
Unit ↑...^
Select totalizer unit for volume flow measurement
0000000000
m
3 ↑…↑...↑...^
Enter preset totalizer value
Reset Yes /
Reset No ↑...^
Do not reset totalizer/
Reset totalizer
Disp. off /
Disp. on ↑...^
Do not display totalizer
Display totalizer /
(available if Maes.Inst =
Norm. Vol., see menu
item 1.1.3)
m 3 norm
Unit ↑...^
Select totalizer unit for standard volume flow
measurement
0000000000
m
3 norm ↑…↑...↑...^
Enter preset totalizer value
Reset Yes /
Reset No ↑...^
Do not reset totalizer/
Reset totalizer
Disp. off /
Disp. on ↑...^
Do not display totalizer
Display totalizer /
(available if Maes.Inst =
Mass, see menu item
1.1.3)
kg
Unit ↑...^
Select totalizer unit for mass flow measurement
0000000000
kg ↑…↑...↑...^
Enter preset totalizer value
Reset Yes /
Reset No ↑...^
Do not reset totalizer/
Reset totalizer
Disp. off /
Disp. on ↑...^
Do not display totalizer
Display totalizer /
3.2.9 E.tot. on
→
(available if DEVICE TYPE
= GROSS HEAT, see menu
item 5.4.1, service menu)
Energy totalizer
Tot. on ↑... Start Totaliser
Tot. off ↑...^ Stop totalizer (value is held)
3.2.10 Energ.Unit
→
(available if DEVICE TYPE
= GROSS HEAT, see menu
item 5.4.1, service menu)
Set unit for heat energy
kJ
Unit ↑...^
Set unit for heat energy
0000000000
kJ ↑…↑...↑...^
Enter preset totalizer value
Reset No /
Reset Yes ↑...^
Do not reset heat energy/
Reset heat energy
Disp. on /
Disp. off ↑...^
Display heat energy /
Do not display heat energy
3.3 HART settings
3.3.1 Poll. Adr.
→
000
0 – 15
↑…→↑...→↑...^
Enter HART polling address for "Multidrop operation"
Version Steam
Level Designation Selection / entry Explanation
MA_OPTISWIRL4070C_R07_en_150606_PRT.book Page 58 Wednesday, February 13, 2013 2:47 PM