Acura 2011 TL - Manual (Page 558)

In this case, the starter motor’s
speed sounds normal, or even faster
than normal, when you turn the
ignition switch to the START (III)
position or on models with keyless
access system, press the engine
start/stop button to set START
Mode (see page
), but the engine
does not run.
Turn the ignition switch to the
START (III) position or on models
with keyless access system, press
the engine start/stop button to set
START Mode (see page
). If
the headlights do not dim, check
the condition of the fuses. If the
fuses are OK, there is probably
something wrong with the
electrical circuit for the ignition
switch or starter motor. You will
need a qualified technician to
determine the problem. See
on page .
If the headlights dim noticeably or
go out when you try to start the
engine, either the battery is
discharged or the connections are
corroded. Check the condition of
the battery and terminal connec-
tions (see page
). You can
then try jump starting the vehicle
from a booster battery (see page
).
Are you using a properly coded
key or keyless access remote (on
models with keyless access
system)? An improperly coded key
or keyless access remote will
cause the immobilizer system
indicator in the instrument panel
to blink rapidly (see page
). 65
178
178
542
572
557
CONTINUED
The Starter Operates Normally
Emergency Towing
If the Engine Won’t Start
T
a
k
ing
Ca
re
of
th
e
U
ne
x
p
e
c
te
d
555
10/07/29 12:53:10 31TK4620_560
2011 TL