Acura 2011 TL - Manual (Page 202)

If either front window runs into any
obstacle while it is closing
automatically, it will reverse
direction, and then stop. To close the
window, remove the obstacle, then
use the window switch again.
Auto reverse stops sensing when the
window is almost closed. You should
always check that all passengers and
objects are away from the window
before closing it.
The driver’s window auto
reverse function is disabled when
you continuously pull up the switch.
When you push the main switch in,
the indicator comes on and the
passengers’ windows cannot be
raised or lowered. Use the main
switch when you have children in the
vehicle so they do not injure
themselves by operating the
windows unintentionally. To cancel
this feature, push on the switch
again. The switch will pop out and
the indicator will go off.
The windows and the main switch
will operate for up to 10 minutes
after you turn off the ignition switch
(set VEHICLE OFF mode on models
with keyless access system).
Opening either front door cancels
this function.
Auto Reverse
Power Windows
Inst
ru
m
e
nt
s
a
nd
Cont
ro
ls
199
NOTE:
10/07/29 12:05:43 31TK4620_204
2011 TL