Acura 2011 TL - Manual (Page 53)

After the belt has retracted, tug on
it. If the belt is locked, you will not
be able to pull it out. If you can pull
the belt out, it is not locked, and
you will need to repeat these steps.
To activate the lockable retractor,
slowly pull the shoulder part of the
belt all the way out until it stops,
then let the belt feed back into the
retractor.
To remove slack, it may help to
put weight on the child seat, or
push on the back of the seat while
pulling up on the belt.
After confirming that the belt is
locked, grab the shoulder part of
the belt near the buckle, and pull
up to remove any slack from the
lap part of the belt. Remember, if
the lap part of the belt is not tight,
the child seat will not be secure. Push and pull the child seat
forward and from side-to-side to
verify that it is secure enough to
stay upright during normal
driving maneuvers. If the child
seat is not secure, unlatch the
belt, allow it to retract fully, then
repeat these steps. 2.
3.
4. 5.
Installing a Child Seat
50
10/07/29 11:46:07 31TK4620_055
2011 TL