Acura 2011 TL - Manual (Page 540)

We strongly recommend that you do
not drive faster than the posted
speed limits and conditions allow. If
you ever drive in a sanctioned
competitive event at sustained high
speeds (over 118 mph or 190 km/h),
be sure to adjust the cold tire
pressures as shown below. If you do
not, excessive heat can build up and
cause sudden tire failure. Every time you check inflation, you
should also examine the tires for
damage, foreign objects, and wear.
You should look for:
Bumps or bulges in the tread or
side of the tire. Replace the tire if
you find either of these conditions.
Cuts, splits, or cracks in the side
of the tire. Replace the tire if you
can see fabric or cord.
Excessive tread wear.
Tire pressure for high speed driving
is the same as for normal driving.
Your tires have wear indicators
molded into the tread. When the
tread wears down, you will see a 1/2
inch (12.7 mm) wide band across the
tread. This shows there is less than
1/16 inch (1.6 mm) of tread left on
the tire.
A tire this worn gives very little
traction on wet roads. You should
replace the tire if you can see three
or more tread wear indicators.
Tire Size Cold Tire Pressure for
High Speed Driving
SH-AWD and SH-AWD TECH models
Except SH-AWD and SH-AWD TECH
models
Tires
High Speed Driving Tire Inspection
Ma
int
e
na
nce
537
INDICATOR LOCATION MARKS
TREAD WEAR INDICATOR
33 psi (230 kPa ,
2.3 kgf/cm )
32 psi (220 kPa ,
2.2 kgf/cm )
P245/45R18 96V
Front:
Rear:
10/07/29 12:51:00 31TK4620_542
2011 TL