GW Instek USG-Series User Manual - Manual (Page 40)

USG Series User Manual
38
Note
Before performing normalization, make sure the
USG has been on for at least 30 minutes to
eliminate drift from effecting the normalization.
Using the Tracking Generator
Description After normalization is performed, the USG can
be used to measure the frequency response of a
DUT.
DUT
Operation 1. Remove the USG from the GSP-730 and put the
DUT between the USG and the GSP-730 RF
ports.
2. Press Sweep or Continuous sweep to get the
frequency response of the DUT.
Display
Normalized spectrum
Frequency response
Example: Low pass filter frequency response.