GW Instek USG-Series User Manual - Manual (Page 15)

GETTING STARTED
13
Function Settings Chooses the type of function to be performed by
the USG: Continuous Sweep, Single Sweep, Single
Point or Hopping.
Frequency Range
Settings Sets the basic start and stop frequency parameter
settings. It also displays the instantaneous
(current) output frequency, as shown below.
Start frequency Stop frequency
Actual frequency
Frequency Status
Bar When the output is on, the point on the frequency
status bar indicates the instantaneous frequency
that is being output. When the output is off, the
status bar can set the start and stop frequencies.
Start key Pressing Start will output the selected function.
About Pressing About will display the GNU lesser GPL
license requirements.
To Main panel Indicates that swiping to the right will go to the
Main panel.
Frequency Setting
panel Indicates that the interface is in the Frequency
Setting panel.
Frequency Offset
Settings Offsets the frequency by ±50 kHz.
Power Sweep
Settings Sets the start and stop power level settings. The
From setting sets the initial power level at the start
of the sweep, and the To setting sets the final
power level at the end of the sweep.