GW Instek USG-Series User Manual - Manual (Page 39)

OPERATION
37
2. Press Single Sweep and perform a single sweep.
 It may take some time to complete a full sweep,
depending on the fixed RBW (1MHz) and span
100MHz settings.
 The Normalize panel will be selectable after the
first sweep is performed.
3. Press Normalize after a full sweep has been
performed. The Normalize radio button will
then automatically be set to ON.
 This will normalize the USG output for the
Primary RF software.
4. Set the normalized amplitude level.
 Normalize: 0 ~ -30dBm.
Display
Normalized spectrum
USG spectrum