Chapter 1 before using the daqstandard, 1 overview of the daqstandard, About dx-p hardware configurator – Yokogawa Data Acquisition with PID Control CX2000 User Manual
Page 9: 1 overview of the daqstandard -1, About dx-p hardware configurator -1, Index
1-1
IM 04L41B01-65EN
1
2
3
4
Index
Before Using the DAQST
ANDARD
1.1 Overview of the DAQSTANDARD
The DAQSTANDARD consists of the following three utility programs.
• Launcher
• Hardware Configurator
• DX100P/DX200P Hardware Configurator
This manual explains Viewer.
Viewer
Viewer displays the values and waveforms of the measured data from the recorder and
prints them.
Hardware Configurator
Hardware Configurator is a software application for creating setup data for the recorder.
It can send setup files that you have created to the recorder and save them to storage
media. It can be used with the following recorders: the DX1000, DX1000N, DX2000,
DX100, DX200, CX1000, CX2000, MV1000, MV2000, MV100, and MV200.
DX-P Hardware Configurator
DX100P/DX200P Hardware Configurator is a software application for creating setup data
for the DX100P/DX200P recorder. It can send setup files that you have created to the
recorder and save them to storage media.
About DX-P Hardware Configurator
Confirming the Setup Data
You can use the Hardware Configurator to display and confirm the setup data.
Creating Setup Data
You can create new setup data by editing the opened setup data.
However, the setup
data of login information and batch system settings cannot be created.
• Create new setup data.
• You can also create setup data by changing the system configuration (number of
measurement channels, options, etc.) of the opened setup data.
• On the DX200P, you can assign screens to the [4 panel] display and set screen
names.
• Load the DX100P/DX200P (hereinafter “the DXP”) setup data via the communication
interface. Transmit setup data to the DXP (function available on DXP style S4 or later).
DXP
(Style S4 or later)
To the DXP
1
2
3
4
5
6
7
8
9
10
26
27
28
29
30
21
22
23
24
25
16
17
18
19
20
11
12
13
14
15
DISP/
ENTER
Communication
via
the Ethernet
List
Setup data
Display the data
Save
Transmit setup data
Receive setup data
Save
CH01 VOLT OFF
CH02 TC
OFF
CH03 RTD OFF
CH04 VOLT ON
CH01 TC
ON
CH02 TC
ON
CH03 TC
ON
CH04 TC
ON
CH01 VOLT OFF
CH02 VOLT OFF
CH03 VOLT OFF
CH04 VOLT ON
................
................
................
Create setup data
Setup data: Setup data of the DXP (.ppl extension).
Chapter 1
Before Using the DAQSTANDARD