Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 34)

2-22
IM04L41B01-65EN
Application
Click here (also selectable from [Setting] - [System Mode Setting]).
Check here if you wish to clear the waveform
display and start data acquisition.
Select the type of process.
Application
Batch: You can sign the batch data in batch units.
Continue: You can sign the continuous data in units of file
Timer (/M1 Option)
Select one.
Select whether or not use [Reset].
Select whether or not use [Save Data].
Click here (also selectable from [Setting] - [System Mode Setting]).
You can set three types of timers. You can have the data saved to a TLOG file or reset
the TLOG computation when the specified timeout time elapses.
Timer Mode
There are two timer modes: absolute mode and relative mode. Select [OFF] to disable
the timer.
• Absolute Mode
Timer expires at times determined from the reference time and the interval.
Interval: Select from [1 min], [2 min], [3 min], [4 min], [5 min], [6 min], [10 min], [12
min], [15 min], [20 min], [30 min], [1 h], [2 h], [3 h], [4 h], [6 h], [8 h], [12 h], and [24 h].
The reference time is specified by the hour (00 to 23).
Ref. time: Select from 0 to 23 hours.
• Relative Mode
The timer is started when the computation is started. The timer is repeated at each
interval. Interval: 1 min to 24 hours
2.6 Configuring the System Mode