Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 28)

2-16
IM04L41B01-65EN
Group/Trip Line
Select the tab of the group
to be configured.
Check the channels that you wish to
register to the selected group (blue: ON).
Select the color of
the trip line.
Set the trip line by dragging.
Set the trip line by
entering a value. Enter the group name.
Click here (also selectable from
[Setting] - [Engineering Mode Setting]).
Turn ON/OFF the trip line display.
Group Name
Up to 16 characters can be entered for the group name.
Number of Channels
The maximum number of channels that can be assigned to a group is 6 for the DX100P
and 10 for the DX200P. The assigned channels are listed under [Channel Configuration].
Trip Line
Up to four trip lines can be set to one group.
With regard to the trip lines set here, the first and second settings (No.1 and No. 2) refer
to the trip lines in the Data Viewer. If you change them here, they will also change in the
Data Viewer.
View Group (for the DX200P Only)
View Group
Up to four view groups can be registered.
Group Name
Up to 16 characters can be entered for the group name. The specified group name
appears as a sub menu of the [4 Panel] display of the DX200P.
Screen Type
The view group is made up of four screens. Select the type of screen to display in each
screen.
Group to Be Displayed
Select the group to be displayed from group 1 to group 6 when the screen type is set to
trend, digital, or bar graph.
2.5 Confiuring the Engineering Mode