Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 49)

3-1
IM 04L41B01-65EN
Receiving and Sending Setup Data
1
2
3
4
Index
3.1 Connecting to the DXP
Notes about Sending and Receiving
Note
• The Communicator Software can connect to the DXP style number S4 or later.
• Only the administrators that are registered to the target DXP can connect to it.
• Connection is not possible if there is a user logged in using the keys on the DXP or if there
is a user connected to the setting function via the communication interface.
• Connection is not possible if a user with the same user name is already connected via
the communication interface (the setting/measurement server, the monitor function of the
maintenance/test server, or the FTP server).
• If the DXP is configured not to use the login function (no administrators are registered), you
can connect to the DXP by entering the IP address or host name in the IP address box.
• The Manager is locked while connected to the DXP.
Password
Note
Default password
For the following cases, enter the default password in the Password box.
• Connecting for the first time after user registration.
• Connecting for the first time after resetting the password because the user was
invalidated.
User Default Password
Administrator 1 to 3 Admin1, Admin2, and Admin3
User 01 to 30 User01, User02, User03, ... , User29, and User30
User Locked
The user who is invalidated through the key operation on the DXP cannot log in from the
DDX-P Hardware Configurator.
When the password is expired
Click here.
Enter the password.
For a description of the password,
see “Note” below.
Note
New password
• Enter the password using 6 to 8 characters.
• Spaces are not allowed.
• Combinations of the user ID and password that have been used in the past are not allowed.
Chapter 3 Receiving and Sending Setup Data