Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 45)

2-33
IM04L41B01-65EN
1
2
3
4
Index
Viewing and Creating Setup Data
2.7 Adjusting the Setup Data (Checking the Data)
Checking the Setup Data
2. If the data are not consistent,
the [Data Adjustment] dialog
box opens (see the description below).
Click here to display the correction list
2. If the data are not consistent,
they are automatically corrected.
1. Click here ([System] - [Data Adjustment]).
or
The data are corrected in the following cases:
• When the values of the items of the Meas/Math tab are outside the range.
• When an invalid character string is used
• When a set point value in the calibration correction setting is wrong.
[Data Adjustment] Dialog Box
Select [View] - [Data Adjustment Dialog] to use the [Data Adjustment] dialog box.
If [View] - [Data Adjustment Dialog Box] is checked, the [Data Adjustment] dialog box will
open when the data are not consistent at the time of the data check or at the time of data
transmission.