Removal – Proface AGP3500 - 10.4 DIO HMI" User Manual
Page 96
Chapter 4 Installation and Wiring
4-17
(4)
Attach the USB cover to attach the USB cable. Insert the USB cover into the tab of the USB holder.
Removal
(1)
Lift up the tab of the USB holder and then remove the USB cover as shown below.
(2)
After removing the USB cable, remove the picks pushing the USB holder from both top and bottom.
• Check the up/down orientation of the USB cover to ensure that the USB cable is
secured properly.
USB Cover
Tab
ST-3200 Series
ST-3400 Series
USB Cover
Tab
USB Holder
USB Cover
Tab
ST-3400 Series
USB Cover
Tab
USB Holder
ST-3200 Series
This manual is related to the following products:
- AGP3400 - 7.5 DIO HMI" AGP3300 - 5.7 DIO HMI" AGP3600 - 12.1 FLEX Network HMIs" AGP3500 - 10.4 FLEX Network HMI" AGP3400 - 7.5 FLEX Network HMI" AGP3600 - 12.1 CANopen HMI" AGP3500 - 10.4 CANopen HMI" AGP3400 - 7.5 CANOpen HMI" AGP3300 - 5.7 CANopen HMI" AGP3300H - 5.7 Handheld HMIs" AGP3750 - 15 Multi-Media HMI" AGP3650 - 12.1 Multi-Media HMIs" AGP3550 - 10.4 Multi-Media HMIs" AGP3450 - 7.5 Multi-Media HMI" AGP3360 - 5.7 Multi-Media HMI" AST3300 - 5.7 Basic HMI" AST3200 - 3.8 Basic HMI" AGP3600 - 12.1 Standard HMIs" AGP3500 - 10.4 Standard HMIs" AGP3400 - 7.5 Standard HMI" AGP3300 - 5.7 Standard HMI" AGP3200 - 3.8 Standard HMI"