Proface AGP3500 - 10.4 DIO HMI" - Manual (Page 13)

12
Be aware of the following items when building the ST into an end-use product:
• The ST unit’s rear face is not approved as an enclosure. When building the ST unit into an end-use product, be sure to
use an enclosure that satisfies standards as the end-use product’s overall enclosure.
• The ST unit must be used indoors only.
• Install and operate the ST with its front panel facing outwards.
• If the ST is mounted so as to cool itself naturally, be sure to install it in a vertical panel. Also, it’s recommended that
the ST should be mounted at least 100 mm away from any other adjacent structures or machine parts. The temperature
must be checked on the final product in which the ST is installed.
• For use on a flat surface of a Type 4X (Indoor Use Only) and/or Type 13 Enclosure.
The safety certificate can be downloaded from Pro-face Home Page.
Home Page URL
http://www.pro-face.com/
CE Marking
The following units are CE marked products complying with the EMC Directive.
The following units are CE marked products complying with both the EMC Directive and low-voltage directive.
For the detailed information on CE Marked, be downloaded and refer the Declaration of Conformity from Pro-face Home
Page.
Home Page URL
http://www.pro-face.com/
About Revision
The nameplate on the ST has the revision code of the ST. In the example below, the asterisk, which is placed at the “A”
position, shows that the revision code is “A”.
AST3201-A1-D24 AST3211-A1-D24
AST3301-B1-D24 AST3301-S1-D24 AST3301-T1-D24
AST3302-B1-D24 AST3401-T1-D24
AST3501-C1-D24 AST3501-T1-D24
AST3501-C1-AF AST3501-T1-AF