4 usb cable clamp attachment/removal, 1 when using the st-3200/3400 series, 4 usb cable clamp attachment/removal -16 – Proface AGP3500 - 10.4 DIO HMI" User Manual
Page 95: 1 when using the st-3200/3400 series -16, Usb cable clamp attachment/removal, 16 4.4 usb cable clamp attachment/removal
ST3000 Series Hardware Manual
4-16
4.4
USB Cable Clamp Attachment/Removal
This clamp is used to prevent the USB cable connected to the USB Host Interface on the bottom of the ST unit
from being unplugged due to vibration or other causes.
4.4.1
When using the ST-3200/3400 series
Attachment
(1)
Before starting the procedure, lift up the tab on both sides of the USB Holder and remove the USB
Cover.
(2)
Attach the USB holder to the USB Host Interface part of the main unit. Hook a pick of the USB holder
to the attachment hole of the main unit and then insert the other (lower) pick to attach the USB holder.
(3)
Insert the USB cable into the USB Host Interface.
Tab
Attachment
Hole
USB Holder
ST-3200 Series
ST-3400 Series
USB Cable
ST-3200 Series
ST-3400 Series
USB Cable
- AGP3400 - 7.5 DIO HMI" AGP3300 - 5.7 DIO HMI" AGP3600 - 12.1 FLEX Network HMIs" AGP3500 - 10.4 FLEX Network HMI" AGP3400 - 7.5 FLEX Network HMI" AGP3600 - 12.1 CANopen HMI" AGP3500 - 10.4 CANopen HMI" AGP3400 - 7.5 CANOpen HMI" AGP3300 - 5.7 CANopen HMI" AGP3300H - 5.7 Handheld HMIs" AGP3750 - 15 Multi-Media HMI" AGP3650 - 12.1 Multi-Media HMIs" AGP3550 - 10.4 Multi-Media HMIs" AGP3450 - 7.5 Multi-Media HMI" AGP3360 - 5.7 Multi-Media HMI" AST3300 - 5.7 Basic HMI" AST3200 - 3.8 Basic HMI" AGP3600 - 12.1 Standard HMIs" AGP3500 - 10.4 Standard HMIs" AGP3400 - 7.5 Standard HMI" AGP3300 - 5.7 Standard HMI" AGP3200 - 3.8 Standard HMI"