IEI Integration WAFER-945GSE v1.04 - Manual (Page 87)

WAFER-945GSE 3.5” Motherboard
Page 67
5.3 Unpacking
When the WAFER-945GSE is unpacked, please check all the unpacking list items listed in
Chapter 3 are indeed present. If any of the unpacking list items are not available please
contact the WAFER-945GSE vendor reseller/vendor where the WAFER-945GSE was
purchased or contact an IEI sales representative.
5.4 SO-DIMM and CF Card Installation
5.4.1 SO-DIMM Installation
WARNING:
Using incorrectly specified SO-DIMM may cause permanently damage
the WAFER-945GSE. Please make sure the purchased SO-DIMM
complies with the memory specifications of the WAFER-945GSE.
SO-DIMM specifications compliant with the WAFER-945GSE are listed
in Chapter 2.
To install a SO-DIMM into a SO-DIMM socket, please follow the steps below and refer to
777H
Figure 5-1.
Figure 5-1: SO-DIMM Installation
Step 1: Locate the SO-DIMM socket. Place the WAFER-945GSE on an anti-static pad
with the solder side facing up.