5 4-com port adapter board connection (optional) – IEI Integration WAFER-945GSE v1.04 User Manual

Page 102

WAFER-945GSE 3.5” Motherboard

Page 82

Chapter 3.

Step 2:

Insert the cable connectors. Insert one connector into each serial port box

headers. See Figure 5-13. A key on the front of the cable connectors ensures

the connector can only be installed in one direction.

Figure 5-13: Dual RS-232 Cable Installation

Step 3:

Secure the connectors. Both single RS-232 connectors have two retention

screws that must be secured to a chassis or bracket.

Step 4:

Connect the serial device. Once the single RS-232 connectors are connected

to a chassis or bracket, a serial communications device can be connected to the

system.

Step 0:

5.7.5 4-COM Port Adapter Board Connection (Optional)

An optional, separately purchased 4-COM port adapter board may be shipped with the

WAFER-945GSE. To install the 4-COM Port Adapter Board, please follow the steps

below.

Step 1:

Locate the COM connector. The locations of the COM port connectors are

shown in Chapter 4.