IEI Integration WAFER-945GSE v1.04 - Manual (Page 112)

WAFER-945GSE 3.5” Motherboard
Page 92
5.9 Heat Sink Enclosure
WARNING:
Never run the WAFER-945GSE without the heat sink secured to the
board. The heat sink ensures the system remains cool and does not
need addition heat sinks to cool the system.
WARNING:
When running the WAFER-945GSE, do not put the WAFER-945GSE
directly on a surface that can not dissipate system heat, especially the
wooden or plastic desk. It is highly recommended to run the
WAFER-945GSE
on a heat dissipation surface or
using copper pillars to hold the board up from the desk below
When the WAFER-945GSE is shipped it is secured to a heat sink with five retention
screws. If the WAFER-945GSE must be removed from the heat sink, the five retention
screws must be removed.