IEI Integration WAFER-945GSE v1.04 User Manual

Page 100

WAFER-945GSE 3.5” Motherboard

Page 80

NOTE:

The SATA power cable described below is an optional item and must

be pre-ordered. The SATA power cable is not shipped with the system.

Step 4:

Connect the SATA power cable. Connect the SATA power connector to the

back of the SATA drive. See

854H809H

Figure 5-11.

Figure 5-11: SATA Power Drive Connection

5.7.3 Serial Port Connector Cable (Four Ports) Cable Connection

The WAFER-945GSE is shipped with one four serial port connector cable. The four serial

port connector cable connects four serial port connectors on the cable to the 40-pin serial

port connector on the WAFER-945GSE. To connect the four serial port connector cable

please follow the steps below.

Step 1:

Locate the serial port connector. The location of the 40-pin serial port

connector is shown in Chapter 3.

Step 2:

Align the connectors. Correctly align pin 1 on the cable connector with pin 1 on