Teledyne LeCroy PETracer EML Analyzer and Exerciser User Manual - Manual (Page 60)

Chapter 4: Software Overview PETracer EML User Manual
52
LeCroy Corporation
Setup Menu
Record Menu
Display Options Allows you to customize display options such as field colors, field formats and level
hiding.
Recording Options Allows you to customize control and setup features associated with recording,
triggering, and filtering recorded events.
Generation Options The Generation Options dialog box is used to set configuration settings in a traffic
generation script (*.peg). This dialog provides a convenient alternative means of
editing a traffic generation file.
Generation Macros Opens a dialog for creating buttons on the status bar that can be used to run traffic
generation macros.
Update Device Opens a dialog box that lets you update the BusEngine™ and Firmware.
Calibrate Device Opens a dialog box that lets you calibrate the BusEngine™ and Firmware.
Analyzer Network Displays the list of PCs with connected analyzers or exercisers that you want
to use for recording or traffic generation .
All Connected Devices Opens a dialog box with a list of locally or remotely connected devices. Allows you to
update the BusEngine, Firmware, and your licensing information.
Start Causes the Analyzer to begin recording traffic.
Stop Causes the Analyzer to stop recording traffic.
Reupload Causes the Analyzer to re-send all or selected portions of the CATC Trace from the
Analyzer buffer to the host PC.
Disconnect/Connect Causes the Analyzer to momentarily break, and then establish the PCI Express link
connection in both link directions.
Reset Link Configuration Causes the Analyzer to reset the Serdes and thereby reset the Analyzers current link
configuration. This command is needed when lane width or other lane settings are
changed. Otherwise, the old link configuration is used and errors are generated in the
CATC Trace.