Teledyne LeCroy PETracer EML Analyzer and Exerciser User Manual - Manual (Page 228)

Chapter 12: Address Space PETracer EML User Manual
220
LeCroy Corporation
Write Address Space Button
The Write Address Space Button brings up a dialog.
Write Address Space Dialog for PETrainer EML
On the PETrainer EML platform, clicking the Write Address Space button opens the
following dialog:
The dialog shows a list of address spaces. Check the checkboxes to select Address
Spaces.
Note: PETrainer memory regions are assigned to the specific BARs according to
configuration space. See “Configuration Space” on page 225.
To select Address Space file(s), click the Browse button .
To edit a selected file, click the Edit button . This action opens either the
Configuration Space Editor or the Memory/IO Address Space Editor depending on which
option you have selected.
To specify the offset from the beginning of the PETrainer memory region, enter a value
into the Offset (bytes) box. The default offset is 0.
To set the size of the data to write, enter a value in the box marked Size (bytes). The
default size is the maximum allowed memory size (limited by PETrainer hardware). The
offset+size should not exceed the maximum allowed memory size (Mem64 = 512 MB,
Mem32 = 128 MB, IO = 256 MB).
Note: You cannot specify Offset and Size for Configuration Address Space.
To load all selected memory regions into PETrainer from the selected files, click the Write
button.
To set all selected memory regions to 0, click the Clear button.