Teledyne LeCroy PETracer EML Analyzer and Exerciser User Manual - Manual (Page 23)

PETracer EML User Manual Chapter 2: Hardware Description
LeCroy Corporation
15
2.6 PETracer EML Analyzer LED Descriptions
When powered on, the PETracer EML activates the user-accessible controls and LEDs
on the front and rear panels of the UPAS.
Warning! Do not open the UPAS enclosure. There are no operator serviceable parts
inside. Refer servicing to LeCroy.
UPAS LEDs (from left to right)
(a) Power indicator LED for UPAS: Lights when the unit power is switched on.
(b) System Status indicator LED for UPAS: Lights during initialization/power up of UPAS
base unit. Blinks if a self-test fails.
(c) Manual Trigger push-button: Forces a CATC Trace trigger.
(d) Triggered LED: Lights when the unit triggers on an event.
(e) Slot 1 Status: Illuminates when the Analyzer in Slot 1 is recording
(f) Slot 2 Status: Illuminates when the Analyzer in Slot 2 is recording
PETracer EML Module
(g) Activity LED: Illuminates when there is traffic on the link.
(h) Analyzer Setup LED: Illuminates when cable is correctly connected between front
of Analyzer and Interposer.
(i) Probe Data Connector