Teledyne LeCroy SierraNet M168 User Manual Ver.1.40 - Manual (Page 113)

SierraNet M168 User Manual 111
Trigger and Filter Settings in Easy Mode Teledyne LeCroy
Timer
You can set a timer independently of any other trigger selection, to cause an
unconditional trigger after a set time.
Double‐click Timer in the Pattern window to open the Add Timer Pattern dialog (see
Figure 2.74 on page 111 ). Check a Time Unit, enter the Timer Value, and click OK.
Figure 2.74: Add Timer Pattern Dialog
Note: The timer and timeout resolution is limited to one DWORD. The minimum value is 12‐13
DWORD.
External Trigger
Please refer to the “Probe Calibration” on page 68 and “External Trigger” on page 81.