Teledyne LeCroy WaveJet 300A Series Remote Control - Manual (Page 57)

WaveJet 300A Remote Control Manual
917976 Rev A
57
DISPLAY VECT
Command/Query
DESCRIPTION The VECT command enable or disable the interpolation
between data points. The VECT? query returns the state
of the interpolation.
COMMAND SYNTAX VECT
:= {ON, OFF}
ON := Displays waveform data in dots.
OFF := Displays waveform data in interpolated line.
QUERY SYNTAX VECT?
RESPONSE FORMAT
REMARKS VECT ON is ignored when XYDS is XY or XYTRG.
Status *WAI
Command
DESCRIPTION The *WAI (WAIt to continue) command rejects permission
to execute the next command until the oscilloscope
completes execution of all of its current commands. If
the sweep method of the instrument is set to "SINGLE",
the *WAI command is used to synchronize the application
program with the completion of waveform data
acquisition.
COMMAND SYNTAX *WAI
QUERY SYNTAX
RESPONSE FORMAT
Data transfer WAVESRC
Command/Query
DESCRIPTION The WAVESRC command selects the trace to which the
waveform data is transferred.
When transferring the waveform data (DTWAVE? query),
it is necessary to set the trace using this command,
to which the waveform data is transferred.
The WAVESRC? query returns the selected channel.
COMMAND SYNTAX WAVESRC
QUERY SYNTAX WAVESRC?
RESPONSE FORMAT
REMARKS