Teledyne LeCroy WaveJet 300A Series Remote Control - Manual (Page 39)

WaveJet 300A Remote Control Manual
917976 Rev A
39
Save/Recall *RCL
Command
DESCRIPTION The *RCL command recalls the oscilloscope front panel
setup data from one of five internal memory areas.
COMMAND SYNTAX *RCL
:0, 1 to 5
0 := to recall default setup.
1 to 5 := to recall setup from one of five internal memory
areas.
QUERY SYNTAX
RESPONSE FORMAT
REMARKS
Horizontal ROLL
Command/Query
DESCRIPTION The ROLL command enables or disables roll operations.
The ROLL? query returns the current roll operation
status.
COMMAND SYNTAX ROLL
:={ON, OFF}
QUERY SYNTAX ROLL?
RESPONSE FORMAT
REMARKS When roll operation is enabled while acquisition is
average, the acquisition mode is set to normal.
Roll operation is turned off when XYDS is XY or XYTRG.
Save/Recall *RST
Command
DESCRIPTION The *RST command enables device reset. The *RST command
recalls the default setups.
COMMAND SYNTAX *RST
QUERY SYNTAX
RESPONSE FORMAT
Acquisition RUN
Command
DESCRIPTION RUN sets the trigger mode to "AUTO" and starts waveform
acquisitions. If the trigger mode is already "AUTO",
this command is ignored. RUN acts same as "TRMD AUTO".
COMMAND SYNTAX RUN
QUERY SYNTAX
RESPONSE FORMAT