Teledyne LeCroy WaveJet 300A Series Remote Control - Manual (Page 40)

WaveJet 300A Series
40
917976 Rev A
Save/Recall *SAV
Command
DESCRIPTION The *SAV command saves the front panel setup data of
the oscilloscope to nonvolatile internal memory.
COMMAND SYNTAX *SAV
:0, 1 to 5
0 := do nothing.
QUERY SYNTAX
RESPONSE FORMAT
Automatic Measurement SKLV
Command/Query
DESCRIPTION The SKLV command defines the measurement conditions of
automatic measurement SKEW specified with the MSEL
command.
The SKLV? query returns the defined measurement
conditions.
COMMAND SYNTAX SKLV , , , ,
is set in a range of 10 to 90 in NUMERIC PROGRAM DATA> format, assuming that P-P of the
waveform is 100%. A value beyond the setting range is
rounded to a permissible value.
:={RISE, FALL}
:={CH1, CH2, CH3, CH4} (WJ354/334/324/314)
:={CH1, CH2} (WJ352/332/322/312)
is set in a range of 10 to 90 in NUMERIC PROGRAM DATA> format, assuming that P-P of the
waveform is 100%. A value beyond the setting range is
rounded to a permissible value.
:={RISE, FALL}
QUERY SYNTAX SKLV?
RESPONSE FORMAT , , , ,
The parameter setting "Level1" of automatic
measurement SKEW is identified in .
The parameter setting "Slope1" of automatic
measurement SKEW is identified in .
The parameter setting "Source2" of automatic
measurement SKEW is identified in .
The parameter setting "Level2" of automatic
measurement SKEW is identified in .
The parameter setting "Slope2" of automatic
measurement SKEW is identified in .
REMARKS If or is set to CH3 or CH4 in the model
WJ352/332/322/312, it is rounded to CH1.
SKLV command reports device-specific error (DDE) when
MSEL is not SKEW.