Teledyne LeCroy WaveJet 300A Series Remote Control - Manual (Page 18)

WaveJet 300A Series
18
917976 Rev A
6. REMOTE COMMANDS
This list of remote commands is alphabetized by short form.
Horizontal ACQ
Command/Query
DESCRIPTION The ACQ command selects the acquisition mode. The ACQ?
query returns the current selection of the acquisition
mode.
COMMAND SYNTAX ACQ
:={NORMAL, PEAK, AVERAGE} (When XYDS is YT)
:={NORMAL, AVERAGE} (When XYDS is XYTRG)
:={NORMAL} (When XYDS is XY)
QUERY SYNTAX ACQ?
RESPONSE FORMAT
REMARKS ACQ AVERAGE sets ROLL OFF automatically.
Acquisition ASET
Command
DESCRIPTION The ASET command provides the auto setup.
COMMAND SYNTAX ASET
QUERY SYNTAX
RESPONSE FORMAT
Horizontal AVGCNT
Command/Query
DESCRIPTION The AVGCNT command sets the number of events to average.
AVGCNT? query returns the number set.
COMMAND SYNTAX AVGCNT
:={2, 4, 8, 16, 32, 64, 128, 256}
QUERY SYNTAX AVGCNT?
RESPONSE FORMAT
REMARKS AVGCNT command reports device-specific error (DDE) and
is not performed when ACQ is not AVERAGE.
Vertical BWL
Command/Query
DESCRIPTION The BWL command enables or disables the bandwidth limit
(low-pass filter) of the specified input channel. The
BWL? query returns the selected status.
COMMAND SYNTAX : BWL
: = {C1, C2, C3, C4} (WJ354/334/324/314)
: = {C1, C2} (WJ352/332/322/312)
: = {OFF, 100M, 20M} (WJ354/334/352/332)
: = {OFF, 20M} (WJ324/314/322/312)
QUERY SYNTAX :BWL?
RESPONSE FORMAT
The current bandwidth limit status (low-pass filter)