Teledyne LeCroy WavePro 7 Zi_Zi-A - Manual (Page 93)

Getting Started Manual
922137-00 Rev A 85
Touch-and-Drag Zooming
1. Touch and drag a rectangle around any part of an input channel
waveform, math trace, or memory trace. The Zoom (Z1 to Z4) dialog
opens.
Note: If you have enclosed a combination of channel and math or
memory traces in the rectangle, a pop-up Rectangle Zoom Wizard is
shown. Touch a Zoom button (Z1 to Z4).
2. Turn off the zoom traces by touching the Undo button at the top-
right corner of the screen.
OR
Uncheck the Trace On checkbox in the dialog for each zoom trace.
Quickly Zooming Waveforms and Multiple
Waveforms
Quickly create a Zoom trace by either pressing the front
panel Zoom button or touching the Zoom button on the
respective channel dialog.
Turning Off Zoom
Turn off a Zoom by either pressing the front panel Zoom button again.
OR
On the corresponding Zoom dialog, touch the Trace On checkbox to
remove the check mark and disable the zoom trace.