Zooming a single channel – Teledyne LeCroy WavePro 7 Zi_Zi-A User Manual

Page 91

Text mode
Original mode

Getting Started Manual

922137-00 Rev A

Zooming a Single Channel

1. On the menu bar, touch Vertical → Channel X Setup....

OR
Touch the channel trace descriptor label for a displayed channel.

2. Touch the Zoom at the bottom of the Cx Vertical Adjust dialog. A

zoom trace (one of Z1 to Z4) is created for the selected channel.

3. Vary the degree of zoom by touching the newly created Zx trace

label. The setup dialog for the zoom (Z1 to Z4) opens. It shows the
current horizontal and vertical zoom factors.

4. If you want to increase or decrease your horizontal or vertical zoom

in small increments, touch the Var. checkbox to enable variable
zooming. Now with each touch of the zoom control buttons, the
degree of magnification changes by a small increment.

If you want to zoom in or out in large standard increments with each
touch of the zoom control buttons, leave the Var. checkbox
unchecked.