Teledyne LeCroy WavePro 7 Zi_Zi-A - Manual (Page 114)

WavePro 7 Zi/Zi-A Oscilloscopes
106 922137-00 Rev A
Pass/Fail Setup on Qx Dialogs
The Qx dialog contains several controls for specifying your Pass/Fail setup.
M
AIN
Q
X
D
IALOG
C
ONTROLS
Use the Source1 control to specify the waveform you'll use for your
Condition.
Set your Pass/Fail condition by touching the Condition control on the
corresponding Qx dialog. The Pass/Fail Condition pop-up is shown.
Select the desired condition.
Note: Right hand dialogs back on the corresponding Qx dialog vary based
on the Pass/Fail condition selected.
The following sections cover the right hand dialogs for Bool identity and
Param and Dual Param Compare. The Mask test condition is covered in
Mask Testing (on page 114).
C
ONDITION
-B
ASED
R
IGHT
-H
AND
D
IALOGS
The following provide some explanation about the different Conditions and
their respective right-hand dialogs.
Boolean Identity
This condition simply passes the input values through as the desired result.