Teledyne LeCroy WavePro 7 Zi_Zi-A - Manual (Page 151)

Getting Started Manual
922137-00 Rev A 143
Date/Time
From the Date and Time tab on the Utilities dialog, you can manually set
the time and date or get it from the Internet. If you elect to get the date
and time from the Internet, you need to have the oscilloscope connected
to the Internet through the LAN connector on your instrument's I/O panel.
You can also set time zones and daylight savings time.
1. You can set the Date and Time manually by providing a value in the
Hour, Minute, Second, Day, Month, and Year using your preferred
input control method. Additional information on using the touch
screen controls can be found in the Dialog Area (on page 33). After
providing values, touch the Validate Changes button.
2. You can set the Date and Time from the Internet by first verifying
that your oscilloscope is connected to the Internet, and then
touching the Set from Internet button.
Note: The Simple Network Time Protocol (SNTP) is used.
3. You can also set the Date and Time using Windows® by touching the
Windows Date/Time button. Windows shows a Date and Time
Properties pop-up where the date and time can be configured.
Options
The Options dialog is used to add or remove software options. To learn
more, visit our Website at teledynelecroy.com/options.
This dialog also shows your ScopeID and Serial #.