Teledyne LeCroy WavePro 7 Zi_Zi-A - Manual (Page 85)

Getting Started Manual
922137-00 Rev A 77
5. Touch inside the trace Intensity data entry control if you want to
change the value.
Enter a value from 0 to 100.
Note: Access the Monitor tab for external monitor display settings.
Refer to the External Display topic for more details.
S
EQUENCE
M
ODE
D
ISPLAY
Set up a Sequence Mode display by first selecting a Sequence trigger mode
in the Timebase → Horizontal Setup dialog. You must also have entered a
Num Segments value. For more information on setting up Sequence Mode,
see the Sequence Sampling Mode (on page 43) topic.
1. Touch Display → Display Setup... on the menu bar.
2. Touch inside the Display Mode control and select a display mode
from the pop-up menu.
Touch inside the Num seg displayed control and enter a value,
using the pop-up keypad.
Touch inside the Starting at control and enter a value.
Moving Traces from Grid to Grid
You can move traces from grid to grid with the touch of a button.
Moving a Channel or Math Trace
1. Touch the trace descriptor label for the waveform you want to
move.
2. Touch the Next Grid button.