Teledyne LeCroy WavePro 7 Zi_Zi-A - Manual (Page 13)

Getting Started Manual
922137-00 Rev A 5
Power Consumption
≤ 800 watts (800 VA) for all 7 Zi and Zi-A series models (depending on
accessories installed - probes, PC port plug-ins, etc.).
Power consumption in Standby Mode: 15 Watts.
Power and Ground Connections
The instrument is provided with a 10A/250V 18AWG rated grounded cord
set containing a molded three-terminal polarized plug and a standard IEC-
60320 (Type C13) connector for making line voltage and safety ground
connections.
The AC inlet ground is connected directly to the frame of the instrument.
For adequate protection again electric shock, connect to a mating outlet
with a safety ground contact.
WARNING. Interrupting the protective conductor inside or outside
the oscilloscope, or disconnecting the safety ground terminal,
creates a hazardous situation. Intentional interruption is prohibited.
Standby Power
The Standby (Power) button controls the operational state of the
oscilloscope. Press the button to switch the instrument On or into Standby
mode (Off).
Always use the Power button or the File > Shutdown menu option to
execute a proper shut down process and preserve settings before powering
down.
Powering off does not disconnect the oscilloscope from the AC power
supply. The only way to fully power down the instrument is to shut down
then unplug the AC power cord from the outlet.
We recommend unplugging the instrument if it will be unused for a long
period of time.