Teledyne LeCroy WavePro 7 Zi_Zi-A - Manual (Page 87)

Getting Started Manual
922137-00 Rev A 79
1. Touch the Dual button on the Display Mode section of the Display
dialog.
2. Touch inside the Grid control on the Grid Mode section of the dialog.
The Select Grid pop-up is shown.
3. Touch the Dual Display category and choose from Single/Single,
Dual/Dual, and Quad/Quad options.
Your grid selection is now shown on both displays.
Persistence
The Persistence feature helps you display your waveform and reveal its
idiosyncrasies or anomalies for a repetitive signal. Use Persistence to
accumulate on-screen points from many acquisitions to see your signal
change over time. The instrument persistence modes show the most
frequent signal path in three-dimensional intensities of the same color, or
graded in a spectrum of colors.
You can show persistence for up to eight inputs for any channel, math
function, or memory location (M1 to M4).
Persistence Setup
Touch Display → Persistence Setup... on the menu bar.
Now, touch the Persistence On checkbox and refer to the following
scenarios based on your needs.
Persistence Setup for All Input Channels at Once
1. Touch the All Locked button.
2. Touch one of the Mode buttons.
3. Touch the Show last trace checkbox if you want the last trace
displayed.