Teledyne LeCroy WavePro 7 Zi_Zi-A - Manual (Page 157)

Getting Started Manual
922137-00 Rev A 149
3. If this checkbox control is available on your oscilloscope, you can
mark the Reset trigger counter before starting a new acquisition
checkbox on the Trigger Counter Setting area of the dialog. This
preference clears the trigger counter each time the oscilloscope
issues an arm acquisition command and applies when you have set a
trigger Holdoff condition in the Trigger dialog in either time or
events:
The default condition of this control is off (unchecked).
For each general category of oscilloscope operation, you can view a
summary of your setups. Access these status dialogs by making the
following menu bar selections:

Vertical → Channels Status

Timebase → Acquisition Status

Trigger → Acquisition Status

Math → Math Status, Zoom Status, or Memory Status
In addition to these dialogs, summaries are also provided for XY setups,
memory (M1-M4) setups, and time stamps for sequence mode sampling.