Teledyne LeCroy WavePro 7 Zi_Zi-A - Manual (Page 100)

WavePro 7 Zi/Zi-A Oscilloscopes
92 922137-00 Rev A
Measure Modes
The selections for Measure Mode allow you to quickly apply parameters for
standard vertical and standard horizontal setups, and custom setups.
Standard Vertical Parameters
These are the default Standard Vertical Parameters:
Vertical
mean sdev max. min. ampl pkpk top base
Standard Horizontal Parameters
These are the default Standard Horizontal Parameters:
Horizontal
freq period width rise fall delay duty num points
Selecting Measure Modes
1. Touch Measure → Measure Setup... on the menu bar.
2. Under Measure Mode, select the Std Vertical or Std Horizontal
buttons.
Note: You can customize parameters by touching My Measure.
Learn more in the Customize a Parameter topic (available in the
online help files).
3. Touch inside the Source data entry control and choose a source for
which the measurements should apply.
Help Markers
Help Markers clarify parameter measurements by displaying movable
cursors and a visual representation of what is being measured. For the at
level parameters, Help Markers make it easier to see where your waveform
intersects the chosen level. This feature also displays the hysteresis band
that you have set about that level.
You also have the option, by means of an Always On checkbox, to leave the
Help Markers displayed after you have closed the Help Markers setup
dialog.