Teledyne LeCroy WavePro 7 Zi_Zi-A - Manual (Page 28)

WavePro 7 Zi/Zi-A Oscilloscopes
20 922137-00 Rev A
A Teledyne LeCroy Zi series oscilloscope showing the four sets of ProBus/ProLink
probe interfaces. Zi oscilloscopes are compatible with all Teledyne LeCroy probes.
The following figure shows a typical channel setup dialog on a Teledyne
LeCroy oscilloscope containing both ProLink (Input A, Upper) and ProBus
(Input B, Lower) interfaces. The input selection is on the left-hand side of
the dialog box. In this case the A input, the ProLink interface is selected.
When the probe is not connected, there is only a C1 tab selection for
vertical channel setup and the user has the ability to select input coupling
and probe attenuation.
The channel dialog layout showing Input A's ProLink interface controls setup
before connection.