IAI America TTA User Manual
Page 63
-63/85-
4-3-45. Position Data Range-Specification Continuous Write 3
(Old: Point Data Range-Specification Continuous Write 3) (290H)
Function: Change position data for the number of change positions from the change start position number.
Data name
Data range (value)
Data size
[bytes]
Cumulative
bytes [bytes]
Endian
Sign extension
Unit Description
Remarks
Big
Little
Yes
No
Command
Header '!'
1
1
Station 'XX(h)'
2
3
Message ID
'290(h)'
3
6
Reserved for system use
’00(h)’
2
8
Change start position
data number
'XXXX(h)' 4 12
Number of change
position data
'XXXX(h)' 4 16
The number of data will be limited based on the
send/receive buffers.
Posi
tion
data
(
*1)
Axis pattern
'XX(h)'
2
18
Acceleration 'XXXX(h)'
4
22
0.01 G
Deceleration 'XXXX(h)'
4
26
0.01 G
Speed 'XXXX(h)'
4
30
mm/sec
Position data (*2)
'XXXXXXXX(h)'
8
38
0.001 mm
Position data
repetition for
remaining effective
axes
Data indicated by *2
for the number of
remaining effective
axes
MAX
56
MAX
94
0.001
mm
Data indicated by *2 x Number of remaining effective
axes = 8 bytes x (Max 8 – 1) axes = Max 56 bytes
Extended data
‘XX(h)’
2
MAX 96
Bits 0 to 3 (spare)
Bits 4 to 5 (SCARA 1 arm system data): 0 = No
specification / 1 = Right arm system / 2 = Left arm
system
Bits 6 to 7 (SCARA 2 arm system data): 0 = No
specification / 1 = Right arm system / 2 = Left arm
system
Position data repetition
for remaining data
Data indicated by *1
for the number of
remaining data
MAX
1599920
MAX
1600016
Refer to the data indicated by *1.
Data indicated by *1 x Number of remaining data =
Max 80 bytes x (Max 20000 data – 1) = Max 1599920
bytes
SC 'XX(h)'
2
MAX
1600018
CR 0Dh
1
MAX
1600019
LF 0Ah
1
MAX
1600020
Normal
re
spon
se
Header '#'
1
1
Station 'XX(h)'
2
3
Message ID
'290(h)'
3
6
Reserved for system use
’XXXX(h)’
2
8
Change start position
data number
’00(h)’ 4
12
Number of changed
position data
'XXXX(h)' 4 16
The number of data will be limited based on the
send/receive buffers.
SC 'XX(h)'
2
18
CR 0Dh
1
19
LF 0Ah
1
20
Error
respon
se
Error response format
Refer to the error
response format.
10 10
(Note 1)
Add H (or h) at the end of each data expressed in hexadecimal notation. If there is no H or h at the end, the data is considered a decimal.
(Note 2)
Data enclosed in single quotation marks indicates an ASCII code. Data is a hexadecimal ASCII code if (h) is added before the closing quotation mark, or a decimal ASCII code if (d) is added before the closing
quotation mark.