IAI America TTA - Manual (Page 33)

-33/85-
Normal response
(Continued f
rom
the previous pag
e)
Detail information 7 'XXXXXXXX(h)' 8 65  
Detail information 8 'XXXXXXXX(h)' 8 73  
Reserved for system
use
'XX(d)' 2 75  
Reserved for system
use
'XX(d)' 2 77  
Reserved for system
use
'XX(d)' 2 79  
Reserved for system
use
'X(d)' 1 80  
Reserved for system
use
'XX(d)' 2 82  
Reserved for system
use
'XX(d)' 2 84  
Reserved for system
use
'XXXX(d)' 4 88  
Message bytes 'XX(h)' 2 90  
* When the X-SEL-R/S/RX/SX/RXD/SXD
controller or TTA is used, the number of
message bytes is fixed to 0.
Message string
String for the
number of
message bytes
MAX
255
MAX
345
 
String data x Number of message bytes = 1 byte
x (Max FFh) = Max 255 bytes
* No message may be responded (the number of
message bytes is 0) depending on the error
number.
SC 'XX(h)' 2
MAX
347
 
CR 0Dh 1
MAX
348
 
LF 0Ah 1
MAX
349
 
Error
respon
se
Error response format
Refer to the error
response format.
10 10  
(Note 1) Add H (or h) at the end of each data expressed in hexadecimal notation. If there is no H or h at the end, the data is considered a decimal.
(Note 2) Data enclosed in single quotation marks indicates an ASCII code. Data is a hexadecimal ASCII code if (h) is added before the closing quotation mark, or a decimal ASCII code if (d) is
added before the closing quotation mark.